Benches

Limits, not brochure numbers

The figures below are the limits we will actually run to with a mounted, instrumented unit. Bare-table ratings are higher and are not what a customer campaign is quoted against.

BenchRangePayloadNotes
Vibration — electrodynamic 5–2000 Hz, sine; random to 12 g rms 40 kg mounted Per-axis fixture; slip table for horizontal runs
Shock — half-sine Up to 40 g / 11 ms 25 kg mounted Six directions; waveform captured per pulse
Thermal chamber A −40 to +150 °C 8 units, 0.6 m³ Programmable ramp 3–10 °C/min
Thermal chamber B −70 to +180 °C 4 units, 0.3 m³ Used for step-stress and cold-start work
Humidity 10–98 %RH, +10 to +85 °C 4 units Condensing and non-condensing profiles
Drop tower 0.3–1.8 m, guided 30 kg Orientation jig for corner and edge drops
Ingress — jet IPX5 / IPX6 / IP69K — Rotating nozzle stand, calibrated flow
Ingress — immersion IPX7 / IPX8, to 2 m — Pressure hold with leak-down observation
Impact IK08 / IK10 — Pendulum, 5 J and 20 J strikers
Instrumentation

What we measure, and how it reaches you

  • ThermocouplesType K, 12 channels per chamber run, 1 Hz
  • AccelerometersTriaxial ICP, 20 kHz per axis on shock runs
  • Rail probes4 differential channels, 100 kHz, ±30 V
  • CurrentHall clamp per unit, 1 kHz, autoranging
  • EnvironmentChamber setpoint, actual, and door state logged alongside unit data
  • ExportOne CSV per channel plus a merged event timeline
Live access. During a run, instrumentation channels are published read-only over WebSocket at /api/v1/telemetry. The handshake and the error codes are documented on the telemetry page. Access is per-campaign and revoked at report issue.
Fixtures

Fixture work is part of the campaign

A result is only as good as the mounting that produced it. We design and machine the fixture for each unit shape, and the drawing goes into the report so a follow-up round can reuse the same mechanical boundary.

Per-axis mounting

Separate fixture per axis rather than a compromise bracket, so the transfer function stays flat through the band that matters.

Representative clamping

Clamped where it will be clamped in service. A unit bolted to a rigid plate passes tests it would fail in the field.

Retained geometry

Fixture drawings are archived with the run ID, so revision two is measured against revision one and not against a new fixture.